NaI(Tl) Scintillator's Response Functions for Point-like and Distributed Gamma-ray Sources

The response functions of a NaI(Tl) detectors have been estimated using Monte Carlo methods. Response functions were calculated for monoenergetic photon sources (0.05 to 3 MeV). Responses were calculated for point-like sources and for sources distributed in Portland cement cylinders. Calculated resp...

ver descrição completa

Detalhes bibliográficos
Autores: Vega Carrillo, Héctor René, Benites Rengifo, Jorge Luís, Hernández Dávila, Víctor Martín, Ortíz Rodríguez, José Manuel, de León Martínez, Héctor Asael
Tipo de documento: artigo
Estado:Versão publicada
Data de publicação:2016
País:México
Recursos:Universidad Autónoma de Zacatecas
Repositório:Repositorio Institucional Caxcán
Idioma:inglês
OAI Identifier:oai:http://ricaxcan.uaz.edu.mx:20.500.11845/785
Acesso em linha:http://localhost/xmlui/handle/20.500.11845/785
https://doi.org/10.48779/cysr-0875
Access Level:Acceso aberto
Palavra-chave:CIENCIAS FISICO MATEMATICAS Y CIENCIAS DE LA TIERRA [1]
Gamma- ray
Point-like source
Distributed source
NaI(Tl) response
Monte Carlo
Descrição
Resumo:The response functions of a NaI(Tl) detectors have been estimated using Monte Carlo methods. Response functions were calculated for monoenergetic photon sources (0.05 to 3 MeV). Responses were calculated for point-like sources and for sources distributed in Portland cement cylinders. Calculated responses were used to estimate the detector efficiency for pointlike and distributed sources. Samples of cylindrical Portland cement were prepared and exposed to the photoneutron field produced by a 15 MV linac used for radiotherapy. Short half-life radioisotopes were induced and the activity was determined by measuring the pulse-height spectra with a NaI(Tl) g-ray spectrometer that was calibrated using point-like sources. Instead of doing corrections due to differences between the geometry, material and solid angle of point-like sources used for calibration, and the Portland cement cylinders, the detection efficiency was determined using the ratio between the efficiencies for the point-like and the distributed sources estimated with the Monte Carlo calculations, and the activity of the induced isotopes in cement was obtained.