On the use of sniffers for spectrum occupancy measurements of Bluetooth low energy primary channels
The methods usually employed to measure channel occupancy show limitations in the context of Bluetooth Low Energy (BLE) advertisements. We propose and analyze the use of BLE sniffers as light and portable low-cost spectrum occupancy meters to be used in scenarios where real time signal analyzers are...
| Autores: | , , , , , |
|---|---|
| Tipo de recurso: | artículo |
| Fecha de publicación: | 2022 |
| País: | España |
| Institución: | Universitat Politècnica de Catalunya (UPC) |
| Repositorio: | UPCommons. Portal del coneixement obert de la UPC |
| Idioma: | inglés |
| OAI Identifier: | oai:upcommons.upc.edu:2117/374986 |
| Acceso en línea: | https://hdl.handle.net/2117/374986 https://dx.doi.org/10.1016/j.measurement.2022.111573 |
| Access Level: | acceso abierto |
| Palabra clave: | Bluetooth technology Spectrum occupancy measurement Channel occupancy Sniffer measurement Bluetooth BLE Bluetooth (Tecnologia) Àrees temàtiques de la UPC::Enginyeria de la telecomunicació |
| Sumario: | The methods usually employed to measure channel occupancy show limitations in the context of Bluetooth Low Energy (BLE) advertisements. We propose and analyze the use of BLE sniffers as light and portable low-cost spectrum occupancy meters to be used in scenarios where real time signal analyzers are not adequate. For the measurement technique to be successful, several low-level effects must be considered. The paper argues about on-air time, receiving blind times due to processing and intra system interference, buffer saturation and frequency anchoring. Hence, a compensation procedure based on collision rate estimation is proposed. Results with the refined method show that occupancies of 40% can be measured with an overestimation error whose percentile 95% is 5 percentage points. This is reduced to 1.9 points when the occupancy is 15%. The sniffers perform in real time and are shown to correctly track short term load variations. The strategy has been successfully used to characterize occupancy in highly variable and loaded scenarios such as subway platforms and a shopping mall. Values up to 25% have been observed, which implies a relevant packet error rate. Hence, the tool can be used to make agile audits and configure the parameters that control communication redundancy in new or existing networks. |
|---|